30.05.2017

System implementation in Rome pilot area is completed!

On May Dynamap noise monitoring devices installation in Rome pilot area was completed. System tests and fault analysis will start quickly to verify its accuracy and reliability. The LIFE DYNAMAP team takes the opportunity to thank the Department of Rome for all the support given during the preliminary tests and installation phases. https://life-dynamap.eu/galleries/

Read more...
05.05.2017

DYNAMAP and The International Noise Awarness Day

During the International Noise Awarness Day, a lesson about noise in one of the schools where a DYNAMAP sensor will be installed has been organized by AMAT and Milan Municipality. At the lesson, the DYNAMAP project was presented to the children and teachers by Mattia Grampella and Stefano Muchetti (AMAT). The photos and the poster […]

Read more...
23.12.2016

Dynamap System Implementation

Dynamap system implementation phase has been started on December 2016: first two sensors have been installed by Anas and Blue Wave Srl in Rome pilot area. https://life-dynamap.eu/galleries/

Read more...
01.08.2016

Dynamap Special Session II

If you’re interested in going through the Dynamap project, don’t miss the Dynamap Special Session II that will be held in Hamburg during Internoise 2016 on August, 24th at 10:20 (Hall A2). The session includes a panel discussion to which you’re very welcome to participate in and give your contribution to the future of noise […]

Read more...
26.04.2016

Monitoring campaign along the A90 motorway in Rome

An extensive monitoring campaign in selected test sites along the A90 motorway in Rome was arranged in order to assess the noise contribution of each source, provide an accurate model calibration and optimize the monitoring station locations. https://life-dynamap.eu/gallery/monitoring-campaign-along-the-a90-motorway-in-rome/

Read more...
26.04.2016

New Bluewave prototype microphone ageing tests

New Bluewave prototype microphone ageing tests are in progress. The ANAS salt spray chamber is used to simulate corrosion in extreme conditions, while detailed tests of microphones thermal response are now being executed using ANAS thermal chamber in order to evaluate the temperature dependance in the range from -10C to +50C as required for class […]

Read more...
26.04.2016

Dynamap Acoustic Monitoring Device

The first prototype of the Dynamap Acoustic Monitoring Device has been installed on a portal of the A90 Motorway in Rome. https://life-dynamap.eu/gallery/dynamap-acoustic-monitoring-device/

Read more...
This site is registered on wpml.org as a development site.